Bundled Watchdog Daemon

When built --with-watchdog a separate service is built and installed in /libexec/finit/watchdogd. If this exists at runtime, and the WDT device node exists, Finit will start it and treat it as the elected watchdog service to delegate its reboot to. This delegation is to ensure that the system is rebooted by a hardware watchdog timer -- on many embedded systems this is crucial to ensure all circuits on the board are properly reset for the next boot, in effect ensuring the system works the same after both a power-on and reboot event.

The delegation is performed at the very last steps of system shutdown, if reboot has been selected and an elected watchdog is known, first a SIGPWR is sent to advise watchdogd of the pending reboot. Then, when the necessary steps of preparing the system for shutdown (umount etc.) are completed, Finit sends SIGTERM to watchdogd and puts itself in a 10 sec timeout loop waiting for the WDT to reset the board. If a reset is not done before the timeout, Finit falls back toreboot(RB_AUTOBOOT) which tells the kernel to do the reboot.

An external watchdog service can also be used. The more advanced cousin watchdogd is the recommended option here. It can register itself with Finit using the same IPC as initctl. If the bundled watchdogd is running a hand-over takes place, so it's safe to have both services installed on a system. For the hand-over to work it requires that the WDT driver supports the safe exit functionality where "V" is written to the device before closing the device descriptor. If the kernel driver has been built without this, the only option is to remove /libexec/finit/watchdogd or build without it at configure time.